Kenny Cutter is back with a complete redeveloped version of IsoCourse! IsoCourse is primarily intended for use as an introduction to CNC programming and the ISO language. In the program the pupil is allowed to do an amount of tests that are defined on the program disk. These tests can be co-ordinate tests, tests for milling machines (X,Y,Z) and tests for lathes (X,Y). The detail in the test is drawn and the pupil is asked to type in the co-ordinates or CNC blocks that are needed to follow the contour. The pupil is given several chances and if the pupil fails to supply the correct answer after an amount of attempts the program shows the correct block and the pupil may continue with the next block. In this way the pupil gets a feel for how a CNC program is developed. All of the pupils answers are stored in the students database and the teacher can at a later time check the pupils results by using the StudentData software. The pupils' motivation is heightened by being allowed to do the tests on the computer instead of simply reading through a book. The book is used as a complement for the program.

In IsoCourse the teacher can create new exercises using the built-in command language where one can easily define new contours and type in the correct CNC blocks. Tests of this program have shown that pupils learn faster and that they can work more independently while the process of learning is perceived as being more "fun". The program does not require any previous knowledge of computers.

Note! This program stores results in the shared student database. Read more here!

 

Download the free 30 days evaluation version!

Download page